Cutlass Bearing

All Forums › General Discussion › Cutlass Bearing

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 6th September 2021 at 9:57 am #13320

      Hi, I have a HT Mk4A which has been standing on the hard for at least 6 years. It has twin Yanmar engines and would like to know if I would need to change the Cutlass bearings before putting in the water due to them drying out, or, is there a proceedure that I should follow if I do not have to renew them. What is the proceedure if they will need changing. Appreciate any help. Regards Steve

      6th September 2021 at 10:49 am #13322

        Hi Steve

        Unable to tell when cutlass bearings need replacing but if the Cutlass bearings need changing then these forum posts may help —

        stern-tube-cutlass-bearing-replacement-advice-needed/

        further-help-needed-with-ht27-cutlass-bearing-removal/

        Geoff Linter is the one to talk to.

        Mike

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • The forum ‘General Discussion’ is closed to new topics and replies.

      Comments are closed.